| Splice &
Seal ™ Splice - Forced Encapsulated Splice Kit
(TPI60-SEK)
The Forced Encapsulated System was designed to reduce overall
cost and to be used on Filled or Air Core PIC cable,
either Direct Buried, Aerial or Underground, Pulp/Paper
Insulated Cable. This has been an
environmentally and mechanically proven closure tested
and installed by major telecoms for over two decades.
All applications of Splice & Seal™ are basically the same. Typical applications include
General Sheath Repair, Pressurized or Non-Pressurized,
Forced Encapsulated Splices, Sheath Pullouts, Auxiliary
Wraps, Insulated Joints, Sheath Dams, Service Wire Splices,
and Pedestal Butt Splices.
Forced Encapsulated Installation Practices (.pdf)
Contents:
| Quantity |
Part # |
Description |
| 1 RL |
TPISEM-18 |
Splice Envelope Material |
| 1 RL |
TPISW-10 |
Spacer Web |
| 10 EA |
TPIF-10 |
Funnels |
| 1 RL |
TPIEC-05 |
Emery Cloth (5' x 1") |
| 1 RL |
TPISRT-2500 |
Strain Relief Tape, 2500 lbs (15') |
| 100 EA |
TPICT-14W |
Wide Cable Tie (14") |
| 50 EA |
TPICT-9N |
Narrow Cable Tie (9") |
| 4 RL |
TPICW-30 |
Clear Wrap, 3 mil |
| 1 RL |
TPIET-15 |
End Tape (1 1/2" x 36 yd) |
| 10 EA |
TPIW |
Cleaning Wipe |
|
